Wayfarer Go Pack Setup: Fit and Loading Tips for Day Hikes

Start with the pack's real dimensions, not a generic daypack checklist

The Wayfarer Go 32L Backpack measures 18.9 x 12.3 x 8.4 inches and holds 32 liters, or 1,952 cubic inches. Those numbers set the working limits for this setup: it is a day-use and commute pack, not a multi-day hauler. The catalog lists best use as camp, day use, hiking and commute, so the loading plan below assumes a single day out or a full day around town.

Before you tighten anything, note that the pack uses a mesh-covered padded back panel and shoulder straps. That padding is there to help you handle full loads in comfort, but it only works if the pack sits against your back rather than hanging off your shoulders.

Fit the Wayfarer Go before you load it

Do this sequence with the pack empty or lightly loaded, then repeat the final check once it is packed.

1. 1. Set the shoulder straps to a starting length: Loosen the shoulder straps so the pack can settle onto your back. The catalog confirms adjustable front webbing straps with buckle closure, which help keep the load inside stable; those are load-control straps, not a substitute for shoulder-strap fit.
2. 2. Seat the padded back panel: Lift the pack slightly and set the mesh-covered padded back panel against your back. The catalog does not provide a torso-length measurement or an adjustable torso system for this model, so treat the fixed back panel as the fit baseline rather than expecting to change its length.
3. 3. Tighten the shoulder straps evenly: Pull both shoulder straps down in small, equal increments until the pack feels close but not restrictive. Because the catalog does not list a sternum strap or load lifters for this pack, do not plan your fit around those adjustments.
4. 4. Buckle the front webbing: Close the front webbing straps with the buckle closure and snug them only enough to stabilize the load. Overtightening pulls the pack tight across the front and works against the padded shoulder straps.
5. 5. Recheck after loading: Once the main compartment, front organizer and hydration sleeve are filled, repeat steps 2 and 3. A 32-liter pack changes shape noticeably when full, so the fit you set empty is only a starting point.

Route hydration before you fill the main compartment

The Wayfarer Go is hydration-compatible for 2 and 3 liter reservoirs, and the reservoir is not included. Set up the bladder and hose first, while the main compartment is still empty enough to reach into. The catalog does not describe a specific hose port or routing path, so check the pack's own openings rather than forcing the hose through a seam.

If you are not carrying a reservoir, the same space can hold a folded layer or a small camp item. The important part is to decide before you pack, because adding a full bladder after the main compartment is loaded means rearranging everything.

What the Wayfarer Go gives you to pack into

• Wayfarer Go Pack Hiking Backpack: 32 liters (1,952 cu. in.) across a large main compartment and a front compartment with organizer. This is the core capacity split: bulk goes in the main compartment, small items go in the organizer, and neither has to absorb the other's load.

  

• Wayfarer Go Pack Hiking Backpack: Hydration-compatible for 2 and 3 liter reservoirs (reservoir not included). Decide your water capacity before loading, since the reservoir sleeve and hose need to be routed first.
• Wayfarer Go Pack Hiking Backpack: 600-denier polyester with a polyurethane coating. The coated fabric supports everyday wear and tear, but the catalog does not claim waterproofing, so pack rain protection separately if conditions call for it.
• Wayfarer Go Pack Hiking Backpack: Dimensions of 18.9 x 12.3 x 8.4 inches. Use these measurements to judge whether the packed bag fits a locker, under a seat or in a car trunk; airline acceptance is not stated in the catalog.

A loading order for a day hike or commute

Load from the back of the pack forward and from heavy to light. The Wayfarer Go's compartments make that order easy to follow.

• Hydration reservoir first: Fill and seat a 2 or 3 liter reservoir before anything else, then route the hose. The reservoir is not included, so confirm yours fits the sleeve before relying on it.
• Heavier items in the large main compartment: Put the densest gear, such as a lunch, a water bottle or a compact layer, in the main compartment and keep it close to your back. The catalog describes the main compartment as large but does not specify internal dividers, so use small stuff sacks if you want separation.
• Organizer items in the front compartment: The front compartment with organizer is the place for small, flat and frequently used items. Keep keys, a wallet and a phone cable there so you are not digging through the main load.
• Quick-access items in the stash and side pockets: The soft-lined front stash pocket, insulated power pocket and concealed side stash pocket are described for fast access to vital gear. Use the soft-lined pocket for items you do not want scratched, and the insulated pocket for whatever you need to keep at a steadier temperature.
• Shoes or damp gear in the shoe tunnel: The shoe tunnel gives you a dedicated place for footwear or items you want separated from the main load. The catalog does not state whether the tunnel is ventilated, so do not assume it will dry wet shoes.
• Close and stabilize: Buckle the adjustable front webbing straps and snug them to keep the load stable. Then repeat the shoulder-strap check from the fitting steps.

Where this pack's setup stops and other choices begin

The Wayfarer Go's catalog record does not list a hip belt, load lifters or a sternum strap. If your day hike involves a heavy load or long hours, those are the features to look for in another pack rather than something you can add through strap adjustment. For a 32-liter day load within the pack's stated best uses, the mesh-covered padded back panel and shoulder straps are the main comfort system you have.

The pack is available in Black and Twill. Color does not change the fit or loading plan, but it is the only option type listed for this model.